3.4 Checking Your Installation

3.4 Checking Your Installation
	Chapter 3. Installation and Setup

You can check your installation using the wizard, as demonstrated here, or by using the Configuration Manager/hs_activate, as demonstrated in the following sections.

Start DriverWizard – <path to Go-HotSwap>/wizard/wdwizard. On Windows you can also run DriverWizard from the Start menu: Start | Programs | Go-HotSwap | DriverWizard.
Make sure that your Go-HotSwap license is installed. If you are an evaluation version user, you do not need to install a license.
Hot plug your board into the CompactPCI bus, and make sure that wizard detects it.

3.4.1 On Windows

Start the Configuration Manager by choosing from the Windows Start menu:
Programs | Go-HotSwap | HotSwap Configuration Manager.

Make sure that your Go-HotSwap license is installed (refer to section 3.3.1, Installation Instructions for Windows).

If you are an evaluation version user, you do not need to install a license.
Hot plug your board into the cPCI bus, and make sure that Go-HotSwap detects it.

3.4.2 On Linux

Run the pre-compiled utility hs_detect
(GoHotSwap/hotswap/hs_detect/.../hs_detect)
Hot plug your board into the cPCI bus, and make sure that Go-HotSwap detects it.


3.3 Go-HotSwap Installation Instructions		3.5 Uninstalling Go-HotSwap